by Regardt Voigt | Jun 11, 2021
The high-speed counter supports 1-phase 1-input, 1-phase 2-input, 2-phase 2-input. The built-in counter in the CPU module can input up to 8ch. However, in the case of 32 point type CPU module, the maximum response frequency differs depending on the channel. –...
by Regardt Voigt | Jun 11, 2021
FX3U-32BL can be used. The battery is not included with the CPU module during factory shipment. The battery can be used to increase the capacity of the latch device/label, as well as to maintain the clock data during power interruption.
by Regardt Voigt | Jun 9, 2021
For GX Works3 Ver.1.025B or later, the simulation function is supported.
by Regardt Voigt | Jun 9, 2021
FX5U CPU module has 2 built-in voltage input channels (DC0～10V) and 1 built-in voltage output channel (DC0 ～ 10V). If an external resistor is connected, the module can also support current input （DC4～20mA). For further details, please refer to MELSEC iQ-F FX5...
by Regardt Voigt | Jun 9, 2021
1. Master station can communicate with the slave stations using the predefined protocol support function. 2. Slave station communication with the master station is supported with CPU firmware Ver.1.060 or above and GX Works3 Ver. 1.040S or above. Also, it is possible...
by Regardt Voigt | Jun 9, 2021
It is necessary to set the latch range from the following GX Works3 parameters: [Navigation Window] -> [CPU Parameters] -> [Device/Memory Settings] -> [Device/Label Memory Area Setting]
by Regardt Voigt | Jun 9, 2021
The default IP address (factory default value) of FX5U/FX5UC CPU modules is 192.168.3.250.
by Regardt Voigt | Jun 5, 2021
There are 3 main types of Melsec iQ-F CPUs, namely FX5U, FX5UC, and FX5UJ. Their differences\Specifications can be found HERE.
by Regardt Voigt | Jun 1, 2021
The Melsec-iQ-F PLC comes in three flavours: FX5U (Standard), FX5UC (Compact) and FX5UJ (Junior). The FX5U is programmed with an Ethernet cable. The FX5UJ can be programmed with either a mini-USB or Ethernet cable. The FX5UC is programmed with an Ethernet cable....
