by Regardt Voigt | Jun 11, 2021
Yes. It is now being migrated to MR-J4 series The following information is applicable: Production Discontinuation of General-Purpose AC Servo MR-J2S/MR-J2M Series
by Regardt Voigt | Jun 11, 2021
The following document is applicable; l Renewal J2S-MR the Select – and can be accessed HERE. also: MR-J2s Renewal Tool for Melservo-J2S Series Using MR-J2S Renewal Tool and: Mitsubishi General-Purpose AC Servo Renewal Tool
by Regardt Voigt | Jun 5, 2021
Some parameters are write-protected. (MR-J4/MR-J3: PA19) The parameter to be displayed is determined by the setting value of this parameter. Do as follows for MR Configurator2. Method 1: Set PA19 to “000E” in the list display and perform the parameter reading after...
by Regardt Voigt | Jun 5, 2021
From Start menu of Windows >, click [All Programs] > – [MELSOFT Application] > – [MR Configurator2] > and you can find “MR-J4(W)-B mode selection” under MR Configurator2. When you use MR-J4(W)-B servo amplifier operated in MR-J3-B compatibility...
by Regardt Voigt | Jun 5, 2021
The alarm E7 (AL.E7) occurs when the forced stop signal of the servo system controller is enabled. Ensure the safety and cancel the forced stop signal of the controller.
by Regardt Voigt | Jun 1, 2021
Mitsubishi Melservo comes in 4 main flavors; MR-JE (simplistic), MR-J2S (discontinued\unsupported). MR-J3 (in the process of phasing out) and MR-J4. In most applications, a battery is not required to be purchased in addition to the amplifier. However, if absolute...
