by Regardt Voigt | Mar 24, 2018 | MR Configurator, MR-J2s, Servo Motors, Servo Systems, Software
Introduction MR Configurator Software is the software specifically used for the configuration of the MR-J2S servo amplifiers. System Configuration and Specifications Related PostsTechnical Tip: CC link IE Field Basic Network GuideDrive System Sizing Software...
by Regardt Voigt | Mar 23, 2018 | MR-J2s, Servo Motors, Servo Systems, Servos
Introduction This article covers two of the most common errors pertaining to MR-J2S Servo drives – namely Al.16 and AL.20. Al.16 and Al.20 The following areas are problematic, related to this error; Connector problems on the cable between the Servo amplifier and...
by Regardt Voigt | Mar 9, 2018 | Servo Motors, Servo Systems, Servos
Introduction This document aims to answer the question about how to update a servo system from the old MR-J2S amplifiers to the new MR-J3 amplifiers, and specifically what to do with the parameter settings. Design Considerations This conversion only applies to the new...
by Regardt Voigt | Mar 5, 2018 | Servo Motors, Servo Systems, Servos
Introduction If for some reason a MR-J3 servo amplifier needs to be replaced, it is possible to maintain the servo position information. Design Considerations On the connection diagram shown below, a special cable is used to connect the servo amplifier to the encoder...
by Regardt Voigt | Feb 28, 2018 | Servo Motors, Servo Systems, Servos
Introduction With a servo system, when the actuator is a conveyor or feed system that always indexes in the forward direction, it can be difficult to divide the encoder resolution into the feed pitch without getting a fraction of a pulse as a remainder. This document...
