by Regardt Voigt | May 28, 2026 | Communication, FX5-20PG-D, FX5U, FX5UC, FX5UJ, iQ-F, Modbus, Modbus RTU
Introduction A short write-up explaining the functions, features, and implementation of the iQ-F PLC Modbus RTU Serial communication, using the built-in serial communication ports. Overview Modbus RTU serial communication on the Mitsubishi iQ-F FX5 PLC enables...
by Regardt Voigt | Aug 21, 2022 | Adroit SCADA, FX5, GX Works 3, iQ-F
Introduction A quick write-up article that could be used to facilitate implementations with regards to the following: ModbusTCP communication-based data transfer (method1) Real values scanning The Method Procedure The FX5 (GX Works3) settingsFirst, we need to ensure...
by Regardt Voigt | Aug 7, 2022 | Adroit SCADA, FX5, GX Works 3, iQ-F
Introduction In connection with the transferring of data between the FX5 and Adroit SCADA using Modbus TCP communication protocol – this write-up will provide the required information to facilitate this requirement. However, please note this is not recommended. The...
by Regardt Voigt | Aug 7, 2022 | Adroit SCADA, FX5U, iQ-F
Introduction There is another method for connecting a Melsec iQ-F PLC to the Adroit SCADA UI. The new method involves the utilization of the Modbus Device allocation Parameters table in GX Works3. This method is ideal if the user requires to scan Modbus device...
by Regardt Voigt | Jul 26, 2022 | Adroit SCADA, Agents, Communication, Ethernet, FX5, GX Works 3, Mitsubishi FA
Adroit SCADA to FX5 PLC connection Firstly The PLC needs to be configured so that it would be able to communicate to Adroit. The right IP address needs to be filled in as well the subnet mask needs to be correct according to your network settings. External Device...
