by Regardt Voigt | Aug 21, 2022 | Adroit SCADA, ENET, FX3U
Introduction The interconnection between a Melsec FX3 PLC and Adroit SCADA using Ethernet-based communication protocol.Since, unlike the FX5 series, the FX3 series does not have a built-in ethernet communication port, an Ethernet communication adaptor (FX3U-ENET-ADP),...
by Regardt Voigt | Aug 21, 2022 | Adroit SCADA, FX5, GX Works 3, iQ-F
Introduction A quick write-up article that could be used to facilitate implementations with regards to the following: ModbusTCP communication-based data transfer (method1) Real values scanning The Method Procedure The FX5 (GX Works3) settingsFirst, we need to ensure...
by Regardt Voigt | Aug 21, 2022 | Adroit SCADA, FR-F8xx, VSD
Introduction This is a very brief explanation of how to setup Modbus Ethernet communication from Adroit SCADA to Mitsubishi F800-E2 drive.Modbus Ethernet addresses can be found in the A800-E/F800-E Ethernet Function Manual available on MyMitsubishi. However, the...
by Regardt Voigt | Aug 7, 2022 | Adroit SCADA, FX5, GX Works 3, iQ-F
Introduction In connection with the transferring of data between the FX5 and Adroit SCADA using Modbus TCP communication protocol – this write-up will provide the required information to facilitate this requirement. However, please note this is not recommended. The...
by Regardt Voigt | Mar 31, 2020 | Adroit SCADA, ENET, FX5, GX Works 3, iQ-F, PLC, Software
Introduction This article is intended to provide a short-summary of how to connect a Melsec iQ-F to Adroit SCADA via an Ethernet communication standard. GX Works3 Configuration In GX Works 3 on the left in the Navigation menu go to Ethernet Port Insert the IP Address...
